Navigator 4WD V8-5.4L VIN 5 (2006)
8. NOTE: The head restraint guides are not interchangeable. Note location for installation.
Reach up into backrest and squeeze the head restraint guide ends together to release and pull the 2 head restraint guides out.
9. CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn
from the seat backrest foam.
Invert the backrest trim cover and remove.
10. CAUTION: Use care when removing the backrest foam pad from the frame. The foam pad has hook and loop fasteners holding the
thermo-electric device to the backrest foam pad.
Separate the backrest foam pad from the backrest thermo-electric device and remove the backrest foam pad.
11. Remove the backrest pivot rod retainer on the end of the backrest pivot rod.
12. Remove the backrest pivot rod cover and slide the backrest pivot rod out from the power recline motor.
13. Disconnect the electrical connector, remove the bolt and the power recline motor.
14. To install, reverse the removal procedure.
15. Install the 40 percent seat.
16. Repower the SRS.
