lincoln Workshop Repair Guides

Lincoln Workshop Service and Repair Manuals

Four Wheel Anti-Lock Brake System (4WABS)|Page 6940 > < Four Wheel Anti-Lock Brake System (4WABS)|Page 6938
Page 5
background image

8. Fill the brake master cylinder reservoir and install the brake master cylinder filler cap.

Brake System Bleeding

Brake System Bleeding

Special Tool(s)

Material

WARNING:  Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will
render the brakes inoperative. Failure to follow these instructions may result in personal injury.

WARNING:  Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.

CAUTION:  Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master cylinder reservoir filled
with the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.

CAUTION:  Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.

NOTE:  When any part of the hydraulic system has been disconnected for repair or new installation, air may get into the system and cause spongy
brake pedal action. This requires bleeding of the hydraulic system after it has been correctly connected. The hydraulic system can be bled manually or
with pressure bleeding equipment.

Four Wheel Anti-Lock Brake System (4WABS)|Page 6940 > < Four Wheel Anti-Lock Brake System (4WABS)|Page 6938