Navigator 4WD V8-5.4L VIN 5 (2006)
brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
1. Check the brake fluid level in the brake master cylinder reservoir.
^
If required, remove the fluid until the brake master cylinder reservoir is half full.
2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
3. Using the large C-clamp, compress the pistons into the caliper housing.
4. CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.
Remove the 2 brake caliper guide pin bolts and position the caliper aside.
^
Support the caliper using mechanic's wire.
^
To install, tighten to 35 Nm (26 ft. lbs.).
5. Remove the brake pads from the caliper anchor plate.
6. Remove the 2 brake caliper anchor plate bolts and the brake caliper anchor plate.
^
To install, tighten to 190 Nm (140 ft. lbs.).
7. To install, reverse the removal procedure.
^
Test the brakes for normal operation.
