Navigator 4WD V8-5.4L VIN 5 (2006)
Using the special tool, install the 3 originally removed camshaft roller followers.
10. Install the CMP sensor and the bolt.
-
Tighten to 10 Nm (89 lb-in).
11. Connect the CMP electrical connector.
12. NOTICE: Only use hand tools to install the camshaft phaser and sprocket assembly or damage may occur to the camshaft or camshaft phaser and
sprocket.
NOTICE: Damage to the camshaft phaser and sprocket assembly will occur if mishandled or used as a lifting or leveraging device.
Tighten the new camshaft phaser and sprocket bolt in 2 stages:
-
Stage 1: Tighten to 40 Nm (30 lb-ft).
