Navigator 4WD V8-5.4L VIN 5 (2006)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the air cleaner housing. For additional information, refer to Fuel Delivery and Air Induction.
3. Remove the generator. For additional information, refer to Alternator.
4. Remove the starter. For additional information, refer to Starter.
5. Remove the RH inner fenderwell.
6. Remove the upper radiator shroud. For additional information, refer to Cooling System.
7. CAUTION: Only use hand tools when loosening the LH engine mount through bolt or damage to the cage nut can occur.
NOTE: If the LH engine mount through bolt nut is missing or damaged install a new nut using service part number W709375. If the LH engine
mount through bolt nut cage is damaged or missing, remove the cage and install a new nut using service part number W520516-S301.
Loosen the LH engine support insulator bolt.
^
To install, tighten to 175 Nm (129 ft. lbs.).
8. CAUTION: Only use hand tools when removing the RH engine mount nut or damage to the engine mount can occur.
Remove the RH engine mount nut.
^
To install, tighten to 175 Nm (129 ft. lbs.).