Navigator 4WD V8-5.4L VIN 5 (2006)
8. Remove the EVAP canister and fuel filler pipe bolt to crossmember.
-
To install, tighten to 15 Nm (11 lb-ft).
9. Remove the 2 EVAP canister bolts to spare tire carrier.
-
To install, tighten to 25 Nm (18 lb-ft).
10. Place the EVAP canister bracket assembly on a clean work surface.
11. Disconnect the hoses and remove the EVAP canister vent solenoid from the EVAP canister bracket.
12. To install, reverse the removal procedure.
-
Carry out the evaporative emission system leak test. See: Testing and Inspection/Evaporative Emission System Leak Test
-
Carry out the evaporative emissions repair verification drive cycle. See: Testing and Inspection/Evaporative Emission Repair Verification
Drive Cycle