Navigator 4WD V8-5.4L VIN 5 (2006)
2. NOTE: The front impact severity sensor is mounted on the bottom of the hood latch support bracket.
Remove the pin-type retainers and lower the front lower splash shield to access the front impact severity sensor.
3. WARNING: The tightening torque of the air bag front impact severity sensor retaining nut is critical for correct system operation.
CAUTION: If the hood latch support bracket or weld stud are damaged in any way that would affect the way the front impact severity
sensor mounts to its original manufactured position, a new hood latch support bracket must be installed.
NOTE:
-
Note the position of the front impact severity sensor locator tabs to the hood latch support bracket alignment holes for installation.
-
Make sure the hood latch support bracket and front impact severity sensor mating surfaces are clean and debris free.
Remove the front impact severity sensor nut.
-
To install, tighten to 12 Nm (9 lb-ft)
4. Disconnect the electrical connector and remove the front impact severity sensor.
5. To install, reverse the removal procedure.
6. Repower the system.
