Navigator 4WD V8-5.4L VIN 5 (2006)
4. Remove the pressure line bracket-to-engine nut.
^
To install, tighten to 40 Nm (30 ft. lbs.).
5. Disconnect the pressure line-to-pump fitting.
^
Discard the Teflon O-ring seal.
^
To install, tighten to 65 Nm (48 ft. lbs.).
6. Remove the 3 pump bolts.
^
To install, tighten to 25 Nm (18 ft. lbs.).
^
Disconnect the harness retainer and remove the power steering pump.
7. To install, reverse the removal procedure.
^
Using the special tool, install a new Teflon O-ring on the pressure line-to-pump fitting.
^
Fill the power steering system.