Navigator 4WD V8-5.4L VIN 5 (2006)
4. Remove the EPC solenoid.
Installation
1. NOTE: Lubricate the EPC solenoid O-rings with clean automatic transmission fluid.
Install the EPC solenoid, bracket and bolt.
^
Tighten to 10 Nm (89 inch lbs.).
2. Inspect the lead frame for damage.
^
Using the special tool, check all lead frame solenoid connections. The gauge should fit tightly and not fall out after being inserted.
^
If the special tool passes through any lead frame connector pins or does not feel like it makes a good contact,
^
Install a new lead frame.