Navigator 4WD V8-5.4L VIN 5 (2006)
8. Lower the transmission on the crossmember and tighten the rear mount nuts.
^
Tighten to 90 Nm (66 ft. lbs.).
9. NOTE: 4x2 shown, 4x4 similar.
Remove the high-lift transmission Jack.
10. Install the 2 bolts retaining the heat shield to the transmission support crossmember.
^
Tighten to 15 Nm (11 ft. lbs.).
4x4 vehicles
11. Install the transfer case.
4x2 vehicles
12. NOTE: The output shaft and the driveshaft are a balanced assembly.