Navigator 4WD V8-5.4L VIN 5 (2006)
11. Remove the 4 nuts retaining the floor shift mechanism to the floor.
^
To install, tighten to 8 Nm (71 inch lbs.).
12. Remove the 3 bolts retaining the upper shift bracket to the console.
^
To install, tighten to 8 Nm (71 inch lbs.).
13. Remove the remaining bolt in the upper shift bracket from the console access panel side of the shift mechanism.
^
To install, tighten to 8 Nm (71 inch lbs.).
14. Disconnect the floor shift mechanism wire harness connector.
15. Remove the floor shift mechanism from the console.
