Navigator 4WD V8-5.4L VIN 5 (2006)
Drive/Propeller Shaft: Service and Repair
Driveshaft - Front
Driveshaft - Front
Material
Removal and Installation
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the rear jack storage area. Failure to do so can result
in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations. Failure to follow
these instructions may result in personal injury.
With the vehicle in NEUTRAL, position the vehicle on a hoist. For additional information, refer to Maint./Service.
2. Remove the 3 front driveshaft shield nuts and the front driveshaft shield.
^
To install, tighten to 25 Nm (18 ft. lbs.).
3. Index-mark the front flange to the pinion flange. Index-mark the rear flange to the transfer case flange.
