Town Car V8-4.6L (2008)
avoid damaging the sensor during wheel and tire disassembly and assembly.
NOTE: Keep the strap parallel with the wheel flange while tightening the worm gear.
Position the worm gear 13-26 mm (0.5-1.0 in) away from the sensor and tighten the worm gear.
^
Tighten to 3 Nm (27 lb-in).
6. NOTICE: The sensor, cradle and strap may be damaged by incorrect tire mounting or dismounting. Mount the tire only as instructed.
Install the tire onto the wheel.
7. NOTE: A new tire pressure sensor is shipped in an off mode (or battery saver mode) and must be turned on before it can be trained. To turn the
sensor on, install it on a wheel, mount the tire and inflate the tire to the recommended inflation pressure. Wait at least 2 minutes, then continue
with the sensor training procedure.
Train the tire pressure sensor(s).
