Town Car V8-4.6L (2008)
31. Connect the passenger air bag module jumper harness to the passenger air bag module electrical connector on the vehicle wiring harness.
32. Connect the battery ground cable.
33. Move the front seats to their highest and most forward position.
34. WARNING: Always deplete the backup power supply before repairing or installing any new front or side air bag supplemental restraint
system (SRS) component and before servicing, removing, installing, adjusting or striking components near the front or side impact
sensors or the restraints control module (RCM). Nearby components include doors, instrument panel, console, door latches, strikers, seats
and hood latches.
Refer to the Description and Operation portion of Air Bag Systems for location of the RCM and impact sensor(s).
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least 1 minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).
Failure to follow these instructions may result in serious personal injury or death in the event of an accidental deployment.
Disconnect the battery ground cable and wait at least one minute.
35. Disconnect the passenger seat side air bag module electrical connector, located at the lower rear of the seat cushion pan.
36. Attach the restraint system diagnostic tool to the seat harness side of the passenger seat side air bag module electrical connector.
37. Disconnect the driver seat side air bag module electrical connector, located at the lower rear of the seat cushion pan.
