Town Car V8-4.6L VIN V Flex Fuel (2006)
Installation
1. Install a new exhaust manifold gasket, the exhaust manifold and 8 nuts.
^
Tighten in sequence shown to 25 Nm (18 ft. lbs.).
2. Install and connect and the LH H02S.
^
Tighten to 41 Nm (30 ft. lbs.).
3. Connect the EGR system module tube to the exhaust manifold.
^
Tighten to 40 Nm (30 ft. lbs.).
4. Position the catalytic converter flange and install the catalytic converter-to-exhaust manifold nuts.
^
Tighten to 34 Nm (25 ft. lbs.).
5. Install the exhaust manifold heat shield and the 2 bolts.
^
Tighten to 10 Nm (89 inch lbs.).
6. Position the intermediate shaft on the steering gear and install the pinch bolt.
^
Tighten to 30 Nm (22 ft. lbs.).
7. Connect the negative battery cable. For additional information, refer to Battery.