Town Car V8-4.6L VIN V Flex Fuel (2006)
Accumulator HVAC: Service and Repair
SUCTION ACCUMULATOR
Removal and Installation
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Recover the refrigerant.
3. Disconnect the suction accumulator outlet fitting.
-
Discard the O-ring seals.
4. Disconnect the suction accumulator inlet fitting.
-
Discard the O-ring seals.
5. Disconnect the A/C cycling switch electrical connector.
6. Remove the 3 suction accumulator bolts.
-
To install, tighten to 15 Nm (11 lb-ft).
7. Remove the suction accumulator.
8. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.