Town Car V8-4.6L VIN W (1997)
NOTE: Allow a minimum of five minutes for glass primer to dry.
10. Apply an even bead of Urethane Adhesive WSB-M2G316-B around entire sheet metal pinch weld next to windshield moulding retaining leg. The
bead should be triangular in shape, 16 mm (0.625 Inch) high and 8 mm (0.33 Inch) at base.
NOTE
^
Leave a door window slightly open until adhesive is cured.
^
Apply new urethane on top of existing material on pinch weld.
11. Install windshield assembly onto vehicle, taking care to align marks on glass to marks on body. This must be done before adhesive skins over.
12. Remove spacer and install headliner, windshield wiper arms, blades, cowl vent screen, visors and windshield side garnish moulding.
13. Install inside rear view mirror.
CAUTION
^
Use only urethane for service of air and water leaks in urethane-set windshield.
^
When replacing urethane-installed glass parts, do not drive the vehicle until the urethane has cured. At temperatures above 13°C (55°F) and
relative humidities above 50%, adequate cure time is typically 12 to 24 hours (less at higher temperatures and lower humidities). See detailed
instructions provided by the urethane manufacturer. Inadequate or improper curing may adversely affect the retention of the windshield.
14. Check installation for air and water leaks in urethane seal.