Zephyr V6-3.0L VIN 1 (2006)
8. Cut the urethane adhesive applicator tip to specification.
9. NOTE: Use either a high-ratio, electric or battery-operated caulk gun that will apply the urethane with less effort and continuous bead.
Apply urethane adhesive on top of the existing trimmed urethane adhesive bead on the pinch weld. Make sure that all gaps in the urethane
adhesive are smoothed into one continuous bead starting and ending at the bottom of the windshield near the center.
10. Install the windshield glass on the vehicle aligning it with the markings made previously.
11. CAUTION: When installing urethane-installed glass parts, the vehicle must not be driven until the urethane has cured. Adequate cure
time is specified on the drive away chart for each urethane product as the temperatures and humidity vary. Inadequate or incorrect
curing can adversely affect the retention of the windshield.
After the urethane has cured, check the windshield glass seal for air or water leaks through the urethane adhesive bead and add urethane adhesive
as necessary.
12. Install the cowl panel grille.
13. Install the headliner.
14. Install the interior mirror.
15. Install the sunvisors.
16. Install the A-pillar trim panels.
