190D 2.5 (201.126) L5-2.5L DSL (602.911) (1987)
1
Nut on drive shaft
2
Spring plan
3
Clutch body
5
Locking ring
6
Bearing for clutch body
7
Pulley
8
Bolt with lock
9
Solenoid coil
10
Locking ring
11
O-ring
12
Slip ring
13
Shaft seal
14
Drive shaft
20
Housing cover
13
Remove installation tool and spacing element.
14
Screw new nut onto shaft (smaller diameter of nut in direction of shaft shoulder) and tighten. Check clearance again.
15
Install refrigerant compressor See: Service and Repair
b) Removing and installing clutch body with pulley, solenoid coil and bearing
Removing
16
Remove spring plate
17
Remove locking ring (5). Mark positions of solenoid coil terminals.