190D 2.5 (201.126) L5-2.5L DSL (602.911) (1987)
/l5-2.5l_dsl_(602.911)/Page-1178002.png)
6.
Route a new wire (red, 6 sq.mm or 8 AWG stranded) from the relay module (N14) to X4/10, located forward of the battery. It is very important
that the new wire is routed exactly as shown. The new wire must be covered with plastic tubing (8.0 sq.mm) before installation.
7.
From relay module (N14), route wire as follows:
around relay module, along front of compartment wall, through compartment grommet (maximum distance from ABS wiring harness), along rear
inside of wall towards center of engine compartment (Figure 3).
8.
Continue alongside the starter wiring harness (through the compartment wall), across the engine compartment (Figure 4).
