190D 2.5 (201.126) L5-2.5L DSL (602.911) (1987)
Removal and Installation
1. Pull off front cover (10) by screwing two bolts into the tapped holes (arrows).
Note:
Do not use the two bolts to press off cover (10). If necessary, loosen cover using a screwdriver.
Installation Note
Clean sealing face of front transmission cover, check gasket for signs of damage and replace if necessary. As a rule, the gasket can be used several
times. It must not be coated with sealant.
Coat bolts with non-hardening sealant and tighten to 13 Nm.
2. Take off the two Teflon rings (9).
Installation Note:
Insert Teflon rings (9) with grease.
Ensure that joint of rings (arrow) stays together.
If necessary remove rings again and shape them to a smaller diameter.