260E (124.026) L6-2.6L (103.940) (1988)
13
Force propeller shaft from centering pin on transmission and rear axle and remove toward the rear.
Caution! If a separation of the propeller shaft is required, reassemble the parts again as shown. The front propeller shaft is provided with a hump
and the fork-type joint of the rear propeller shaft with two arrow-type humps. The hump of the front propeller shaft should be located between the
two arrows on fork-type joint (arrows).
14 Check flexible coupling, centering sleeves, vibration damper
Note: A soft or hard pull-push flexible coupling (except on models 124.333/393) is installed on the transmission and a hard flexible coupling is
installed on the rear axle.