300CD (123.153) L5-3.0L DSL Turbo (617.952) (1982)
Suspension Spring ( Coil / Leaf ): Technical Service Bulletins
Suspension - Tool Updated Universal Spring Compressor
TO:
OUR MERCEDES-BENZ PASSENGER CAR DEALERS
DATE:
September 1986 REF..NO. 32/28, 58/42
SUBJECT:
UNIVERSAL SPRING COMPRESSOR ALL MODELS
FIGURE 1 - SPRING COMPRESSOR FOR FRONT AND REAR SPRINGS
The spring compressors previously used for front and rear suspensions are replaced by one universal spring compressor plus two additional clamping
plates.
IMPORTANT! Because of the Powerful spring forces involved, the spring
compressor should be guided through the clamping plates and securely locked in position before attempting to compress a suspension spring. To firmly
lock the spring compressor, it has to be turned 90~ (1/4 turn) for the lugs to properly rest in the semi-circular recesses in the center of the clamping
plates. For safety reasons, the use of an impact wrench for compressing or releasing a spring is not recommended. Springs are easily removed or installed
if a maximum number of coils are fully compressed. The spindle and piston inside the tensioning cylinder should be periodically lubricated with
Molykote paste.
Change in application of this universal spring compressor versus the old type.
Front suspension springs, models 116, 123, 126
Guide tensioning cylinder from engine compartment through opening in upper spring mount and through both clamping plates. Using a screwdriver, turn
the cylinder 90~ (1/4 turn) to lock it in position.
Rear suspension springs, models 124, 201
To remove the compressed spring, remove the hexagon head bolt between the spring link and rear axle carrier. Lower the spring link. Tighten tile rear
spring link mounting only if vehicle rests on its four wheels, or the rear axle shaft is in a horizontal position.
Application
Description
Suitable for
Front spring
Rear spring
Spring compressor with
116
124
2 plates (120 mm dia.)
123
201
124 201
Spring compressor with
126
107