300CE (124.050) L6-3.0L (103.983) (1989)
/l6-3.0l_(103.983)/Page-1603003.png)
8.
Insert new left rubber mount into the rear axle carrier with gap at the bottom. Continue to press in until bolt of test arm (01a) is in enter of front
oval bore (arrows) (Figure 4).
9.
Install rear axle center piece.
10.
Install drive shaft intermediate bearing.
11.
Install heat shield above exhaust system.
12.
Suspend exhaust system on rubber hangers.
Special Tool Information
Parts Information
