300E (124.030) L6-3.0L (103.983) (1986)
FIGURE 8
Modification Procedure
1.
Remove radio.
2.
Remove spring contact with harness and discard.
3.
Exchange the radio chassis bottom cover for one equipped with a spade connector at its rear center, if not already so equipped (Figure 8).
4.
Affix installation note label directly below existing label reading "2 X 20 Watt..." to top cover of radio chassis.
Note:
Exchange radios manufactured after 10/86 already have the new cover and label. For these radios, disregard steps 2 and 3.
FIGURE 11
5.
Push positive-lock plug (S 62/4, Figure 11) of the new harness onto spade connector (ground) and 5-pole plug onto radio chassis.
Caution:
Connect positive-lock plug first, the 5-pole plug second.
6.
Push 1-pole (X 40, Figure 11) of harness onto coupling of anti-theft alarm wiring harness, where previous spring contact was connected.
7.
Make sure that the positive-lock plug is not disconnected when installing the radio chassis in the console.
8.
Enter remark, "Positive-lock connection installed on radio antitheft alarm harness: (date)", in inside cover of vehicle's maintenance booklet.
Parts Information
Part Name
Part
Harness
201 540 50 34
Bottom cover and
900 820 00 22
label (installation note by Becker)