300E (124.030) L6-3.0L (103.983) (1986)
Figure 4
12.
Test coolant for sufficient antifreeze protection, refill and bleed cooling system. Pressure test system for leaks (Figure 4).
13.
Run engine. Check for proper coolant level.
Parts Information
Qty. Part Name
Part Number
1.
Block heater kit
606 200 00 96
1.
Heat shield
602 200 00 94
2.
Screw (M6X15)
000933 006102
2.
Spring washer
000137 006204
6.
Cable ties, Local purchase
Suggested Time Allowance Information
Note:
The subsequent installation of a block heater in these models is at the customers expense.
Operation:
Block heater, subsequent installation
Operation Number
Time (hrs.)
Model Indicator(s)
20-5480
2.0
25, 45, 62, 63, 64, 65,
74, 75, 80, 91, 95, C2, E2
Operation no. and time are subject to change, refer to latest warranty Time Guide.
Models 129.066/067 (With Engine 119)
MODELS 129.066(067 (WITH ENGINE 119)
1.
Lift vehicle
2.
Remove lower engine panel
3.
Drain engine coolant at lower right radiator fitting. Drain coolant into a suitable container for reuse later.
4.
Remove secondary air injection elbow below core plug (5 mm Allen screws) and move aside.