300E (124.030) L6-3.0L (103.983) (1986)
Model 201, As of M.Y. 1985
1
Reclaim and recycle A/C refrigerant.
2.
Remove lower engine compartment encapsulation panel.
3.
Release tension and remove poly-V-belt.
4.
Disconnect 3-pole connector (A9x) on A/C compressor.
5.
Remove screw (14) securing suction/discharge line to manifold.
Tightening torque: 23 +/- 2.3 Nm.
6.
Remove bolts (7 and 11) and remove bracket (8). Tightening torque: 23 +/- 2.3 Nm.
7.
Remove A/C compressor downwards.
8.
Remove manifold. Remove shipping plate from remanufactured unit only after releasing pressure via the schrader valve. Install manifold and new
O-rings onto remanufactured unit.
9.
Correct oil level in compressor (compensate for oil loss if additional components were replaced).
10.
Reinstall in reverse sequence.
Note:
If clutch must also be replaced, see section H.
11.
Replace receiver/drier (SMS, Job No. 83-540).
12.
Evacuate and recharge A/C system. Run engine at idle for approximately four minutes and check for proper function and leaks (SMS, Job No.
83-508).
B. Engine 103/104
Models 124, 126, 129, 201