300E (124.030) L6-3.0L (103.983) (1986)
4
Remove spring retainer (4) and compression springs (3).
Installation Note
Pay attention to number of return springs and make sure that each spring is centered by a guide lug of spring retainer.
5
Pull piston (2) out of outside plate carrier (1).
NOTE: Check O-ring between outside plate carrier and piston guide ring for leaks. For this purpose, fill some kerosene or benzine into piston guide
ring. Then watch whether fluid flows off. In the event of leaks, replace outside plate carrier.
Installation Note
Check sealing rings (12 and 13) for wear or damage and replace, if required.
6
Insert sealing ring (12), making sure that the sealing ring is not twisted.
7
Insert lip sealing ring (13) into piston (2) in such a manner that the sealing lip is pointing downwards (in direction of arrow).