300SD (140.134) L6-3.5L DSL Turbo (603.971) (1993)
/l6-3.5l_dsl_turbo_(603.971)/Page-1284006.png)
NOTE: When installing insert O-rings or Teflon rings (53 and 56) into the pitman arm shaft/bearing cover.
5. Examine needle sleeve (52) in pitman arm shaft bearing cover for signs of wear. If the needle sleeve (52) is worn, replace pitman arm shaft bearing
cover complete.
6. Examine pitman arm shaft (43) at the tooth segment and at the bearing points for signs of damage and wear as well as for twist (detectable from
displaced teeth).
Removing and Installing Adjusting Screw
Removing and Installing Adjusting Screw on Steering Gear with Adjusting Screw Below (Model 140):
-
Remove steering gear, if not already done.
-
Follow the procedure of removing and checking the "bearing cover with pitman arm shaft" before proceeding with this procedure.
-
For information on procedure specific special tools, See: Tools and Equipment
After the above criteria are met, proceed as follows:
