300SDL (126.125) L6-3.0L DSL Turbo (603.961) (1987)
Governor: Service and Repair
Removal and Installation of Centrifugal Governor
NOTE: Tightening torque on Nut for centrifugal governor axial holder = 8 Nm
Removal
1
Remove rear engine mount
2
Unlock plug (8). while turning white plastic ring upwards in direction of arrow.
3
Pull off plug (8).
4
Push-in cover (46), remove circlip (47) together with cover.
5
Loosen nut (44) for axial holder.
6
Swivel axial holder (43) with screw driver at slot (arrow) counterclockwise (according to position "B" in sectional view).
7
Pull out centrifugal governor (50).