300SEL (126.025) L6-3.0L (103.981) (1988)
Sunroof / Moonroof Weatherstrip: Service and Repair
Removal/Installation of Sealing/Rails on Sliding-Lifting Roof
Sliding-lifting roof ................................................................................................................................................................................ Open, do not remove
Installation position of sealing ................................................................................................................ Mark on roof cutout at connecting points (arrows)
Sealing (1) ..................................................................................................................................................................... Pull out of holding rail 2, 3, 4 and 5
Wind deflector .................. Remove and install See: Roof and Associated Components/Sunroof / Moonroof/Sunroof / Moonroof Windguard/Service and
Repair
Screw (6) .......................................................................................................................................................................................... Screw 6 each out and in
Holding rail (2) ............................................................................................................................................ Remove and install (refer to Installation note)
Screw (7) and (8) .............................................................................................................................................................................. Screw 8 each out and in
Holding rail (3) and (4) ....................................................................................................................... Slip toward the rear and remove in upward direction
Holding rail (5) Can be removed and installed only after removing sliding-lifting roof frame and boring out rivets (11 each)
Sealing (1) Push into holding rail 2, 3, 4 and 5. The corrugations on plug profile should point upwards.
Installation note
To make sure that the sealing (1) in holding rail 2, 3 and 4 is adequately held in place, a gap dimension of 3 mm must be maintained between holding rail
and roof panelling.