300TD (123.193) L5-3.0L DSL Turbo (617.952) (1984)
3
Loosen necked-down screws. Remove flywheel, driven plate and spacing washer.
NOTE: The flywheel and crankshaft are identified by a mark (arrows).
Installation
4
Measure necked-down stem dia. "d" of necked-down screws.
If the minimum dia. has been attained, replace necked-down screws.
5
Position flywheel, driven plate and spacing washer on crankshaft journal in such a manner that the marks are in alignment.
6
Lubricate necked-down screws, screw-in and tighten to 30 - 40 Nm.
7
Tighten to angle of rotation torque of 90-100° by means of angle of rotation tool.
Flywheel and driven plate
45a
Ring gear
46a
Flywheel
48
Driven plate
49
Spacing washer
50
12 necked-down screws