300TE (124.090) L6-3.0L (103.983) (1989)
Technical Service Bulletin # 83_022A
Date: 880501
A/C - Not Functioning Properly
REF. NO. MBNA 83/22A
TO: OUR MERCEDES-BENZ PASSENGER CAR DEALERS
DATE: MAY 1988 (Supersedes S.I. MBNA 83/22 DEC. 1986)
SUBJECT:
INSTALLING SPLASH GUARDS TO PREVENT BELT SLIPPAGE
MODEL 124 WITH ENGINE 103
NOTE:
This S.I. and attached W.I. contain updated installation, parts and time allowance information. Please discard your copy of S.I. MBNA 83/22 and W.I. #
207.
The A/C compressor has a speed sensor which can detect belt slippage, which can be caused by water splashing onto the single belt drive. When slippage
is detected, a signal is sent to the control unit resulting in the A/C compressor clutch disengaging.
The compressor clutch will reengage when the ignition switch is turned off and then on again.
In case of customer complaints regarding the ACC system not functioning properly after driving through water, splash guards can be installed as
described in the Work Instructions # 207A as shown.
Parts Information
Time Allowance
Work Instructions
No. 207a
GRP. 83
Date: May 1988
SUBJECT:
INSTALLING SPLASH GUARDS TO PREVENT BELT SLIPPAGE
MODEL 124 WITH ENGINE 103