380SL (107.045) V8-3.8L (116.960) (1982)
3
Mount connecting rod bearing cap and tighten connecting rod nuts to 40 - 50 Nm.
4
Measure connecting rod bearing basic bores. If basic bore exceeds the specified value or is conical, touch up bearing cap mating surface on a
surface plate up to a maximum of 0.02 mm.
5
Press in new connecting rod bushing so that the oil bores are in alignment. Pressing-in pressure at least 2500 N.
6
Machine or ream connecting rod bushing.
7
Touch up lateral connecting rod contact surfaces on a surface plate.
8
Square connecting rod with connecting rod tester.