380SL (107.045) V8-3.8L (116.960) (1982)
8
Place spacer (2) on spring plate (1). Insert installer (3) through spacer (2) and screw installer (3) to shaft end.
9
Hold hexagon of tool in position and screw-in center screw by several turns to press spring plate in part on shaft.
10 Remove installer (3) and spacer (2), check key and key groove for alignment. If both are correctly aligned, mount installer again and continue
pressing spring plate (1) on shaft until a distance of approx. 1 mm to 1.5 mm is obtained between the friction surfaces of the pulley and the spring
plate.
11 Remove installer (3) and spacer (2).