380SL (107.045) V8-3.8L (116.960) (1982)
Hard top removed or roadster top folded back. Side panelling in rear compartment removed.
-
Turn ignition key to position "0".
-
Disconnect and cover battery negative terminal.
-
Vehicles with airbag: Disconnect red 10-pin plug connection in passenger's footwell. See: Air Bag Systems/Air Bag Safety Switch/Connector
-
Unscrew bolts (1 & 2).
-
Remove cover (3).
-
Unscrew bolt (4) on sash guide. Tighten to 35 Nm on re-installation.
-
Press off cover on seat frame.
-
Unscrew bolt (6). Tighten to 35 Nm on re-installation.
-
Disconnect plug connector of belt tensioner detonator.
-
Unscrew bolt (7) on belt retractor. Tighten to 35 Nm on re-installation.
-
Remove belt tensioner.
Installation is the reverse of the removal procedure.
Installation Note: When installing the belt tensioner(s), note that there are different versions (for left and right) and ensure that it locates correctly in
the catch.
B. Model 123
Removal:
1. Turn ignition key to position "0". Disconnect and cover battery negative terminal.
2. Remove floor mat in left-hand front footwell.
3. Open flap in foot rest and pull off red 10-pin plug connection of triggering unit on the back.
4. Remove covering on right-hand center pillar.
5. Unscrew bolt on sash guide.
6. Unscrew mounting bolt on side member and on belt tensioner.