1982 Mercedes 380SL 38L Ignition Lock Component Service
Ignition Lock: Service and Repair
Steering Lock Versions
NOTE: THREE types of steering lock assemblies were used on this vehicle. VERSION 1 uses a plug-type chrome cap. VERSION 2 uses a plug-type
plastic cap. VERSION 3 uses a screw-on cap. Component replacement for all three types is the same except where indicated in the text.
The steering lock assembly is comprised of three main components:
1.
Ignition lock (locking cylinder)
2.
Ignition switch (starter switch)
3.
Steering column lock (steering lock)
Use this procedure to replace the IGNITION LOCK. Additional information is also available for IGNITION SWITCH LOCK CYLINDER
replacement and IGNITION SWITCH replacement.
REMOVAL
1.
Disconnect battery. Remove steering wheel.
2.
Remove instrument cluster by pulling out as far as possible. Remove tachometer cable, electrical connectors, and oil pressure line.
3.
Remove driver's side under-dash panel.