380SL (107.045) V8-3.8L (116.960) (1982)
3
Lower control arm
7
Supporting joint
10
Front spring
11
Front shock absorber
12
Torsion bar
29
Rubber mount
4. Support lower control arm with pit lift, attached intermediate angle piece (47) and cradle (44). Knock out cam bolt (30) and carefully lower pit lift.
Make sure that the cam bolts are not mixed up!
Note:
The cradle (44) has two supporting points for the receiving bolt. The illustration shows the use of the device on left end of vehicle, change
bolt around for right end.
When using the intermediate angle piece (47), in combination with a pit lift, secure pit lift against lateral tilting
1
Front axle carrier
3
Lower control arm
4
Upper control arm
10
Front springs
5. Remove cradle (44), swivel control arm forward and remove front spring with rubber ring (31).
Clean control arm in range of supporting face of front spring, as well as on lower shock absorber fastening point.
Installation