380SL (107.045) V8-3.8L (116.960) (1982)
/v8-3.8l_(116.960)/Page-949006.png)
Attention!
On transmission 722.323 220 kW, 722.324 and 722.325 the piston guide ring is held by means of a circlip (refer to drawing).
8
Remove circlip (16) and pull out piston guide ring (18). Remove sealing ring (17). For installation proceed vice versa.
Installation Note
Insert valve ball (19) with grease into piston guide ring (18). Lubricate piston guide ring and sealing ring with ATF oil prior to installation.
9
Place installation sleeves (021) and (022) into outside plate carrier (1). Lubricate installation sleeves, as well as lip sealing rings (12 and 13) with
ATF.
NOTE: On insertion sleeves of 1st production run, remove beaded edge for approx. 5 mm on lathe so that the insertion sleeve rests on piston
guide ring. Installation sleeves 126 589 03 14 00, 126 589 10 14 00 and 126 589 02 14 00.
