380SL (107.045) V8-3.8L (116.960) (1982)
Crankshaft, V-belt pulley, vibration damper, driven plates and ring gear are individually balanced, and can be renewed without additional balancing.
Removal
1
Remove transmission.
2
Unscrew necked-down bolts, spacer plates and driven plates with ring gear.
Installation
3
Measure necked-down shank. If the specified minimum diameter "d" on the necked-down shank is reached, the necked-down bolts must be
renewed.
Microencapsulated bolts may only he used once otherwise the sealing effect is impaired.
NOTE: One of the eight securing bolts is positioned off-centre in the pitch circle diameter (arrow). The driven plates therefore have to he
installed in a certain position. The holes must be exactly aligned.
4
Screw in stretch bolts or microencapsulated bolts and tighten to an initial torque of 30 - 40 Nm and an angle of rotation of 90 - 100°.