380SL (107.045) V8-3.8L (116.960) (1982)
/v8-3.8l_(116.960)/Page-1700004.png)
11
Position reversible ratchet (3) on windlass (15) and tension cutting wire (17). Then check from outside whether the cutting wire (17) makes contact
to the adhesive seam on the window all-round.
The coil of the windlass (15) can only be turned in one direction, therefore it is necessary to ensure that the cutting wire (17) is located in the guide
groove (20) of the windlass (15).
12. Insert suitable interior protection (10) between cutting wire (17) and inner paneling.
Use parabolic chisel (1) at points not easy to reach.
13
Slowly wrap cutting wire (17) onto coil of windlass (15) and cut out window up to marking (B).
14
Remove reversible ratchet, parabolic chisel and interior protection and turn windlass (15) to next position.
To move windlass (15), release locking knob (19) while retaining under tension the cutting wire (17) of the coil.
15
Install reversible ratchet, parabolic chisel and appropriate interior protection.
16
Install windlass (16) on inner side of window.
17
Install second end of cutting wire (17) in coil of windlass (16).
18
Install reversible ratchet on windlass (16) and tension cutting wire (17).
The windlass coil (16) can only be turned in one direction. Ensure that the cutting wire (17) is located in the guide groove of the windlass (16).
19
Insert suitable interior protection between cutting wire (17) and inner paneling.
Use parabolic chisel at awkward locations.
20
Slowly wrap cutting wire (17) onto coil of windlass (15) and cut out window up to marking (C).
