560SEL (126.039) V8-5.6L (117.968) (1986)
Layout sedan
4
Pressure reservoir
4b
Connection on pressure reservoir
5
Spring strut
18
Rear spring
50
Connection on spring strut
B2
Pressure line level controller- pressure reservoir
B3
Pressure line pressure reservoir - spring strut
3. Loosen the three hex. bolts for attaching pressure reservoir to frame floor.
4. Close pressure lines and connections of pressure reservoir by suitable plugs.
Installation
Note:
Pressure reservoirs of 1st version (up to May 1978) can be mounted on rear axle during repairs together with pressure reservoirs of 2nd
version (starting June 1978). Pressure reservoirs of 2nd version are lighter in weight and smaller (part no.123 320 00 15).
5. Attach pressure reservoir to frame floor.
6. Connect pressure lines (B2 and B3), making sure that line (B3) designed as pressure hose is not chafing against frame floor.
7. Fill pressure oil system and check for leaks. Refer to Suspension Control, Service and Repair, Automatic Suspension, Draining and Filling
Hydraulic System. See: Service and Repair
Attention!
When scrapping pressure reservoirs, respective safety rules must be observed.
Carefully release pressure reservoirs with gas filling screw (1st to 3rd version) on dome-shaped face, let gas flow out and completely
remove screw (arrow).