C 230 (203.040) L4-1.8L SC (271.948) (2005)
Screw on sliding roof drive
TORX - 4 N.m
Hexagon socket - 4 N.m
See "Special Tool" given below.
6
Decouple sliding roof drive from sliding/tilting roof surround
NOTE:
-
Until the drive gear is no longer meshed with the cables (7).
-
Installation: Before fastening sliding roof drive, check position of tip (8) in relation to edge of lever (9). The tip in the opening on the tilting
bracket should coincide with the edge of the lever in front. Correct tilting bracket if necessary.
Screw on sliding/pop-up roof frame - 8 N.m
7
Unscrew screws (2) on both sides
8
Remove screws (3) on both sides
9
Pull off cover (4) in direction of arrow on both sides
10
Push tilting bracket (5) approx. 10 cm to rear on both sides
11
Push cable (7) forward about 10 cm on both sides
12
Pull out pull cable (7) toward rear on both sides
13
Install in the reverse order
Special Tool
Torx Bit Set