C 230 (203.040) L4-1.8L SC (271.948) (2005)
NOTE: Operate brake pedal several times until vacuum in brake booster is reduced.
5
Unfasten module housing (120) and push to the side
-
Refer to, removing and installing module housing
6
Remove mechanical stop lamp switch
7
Remove cover above pedal assembly
8
Pull locking element (25) off brake booster to brake pedal and pull out pin (26)
9
Unscrew retaining nuts (23) for brake booster
10
Remove brake booster (16)
CAUTION: Do not damage the front timing case and the rubber sleeve when removing and installing the brake booster.
NOTE: Installation: Replace gasket (21) if necessary.
11
Install in the reverse order