C 230 (203.040) L4-1.8L SC (271.948) (2005)
The thrust plates are assigned to the fitted bearing by means of the numbers 1 or O (see table). These are engraved on the journal of the crankshaft
(arrow). m The thrust washers installed must have the same designation.
4 Insert crankshaft (7).
5 Install top thrust washers (8).
The oil grooves of the thrust washers (8) must point towards the crankshaft webs (1 O).
6 Install the crankshaft bearing caps (2) according to the marking. When installing the fit bearing cap (3) hold both thrust plates (8) tight.