C 230 (203.040) L4-1.8L SC (271.948) (2005)
7.10 Solder the 3 wires from the new ignition module onto the supply lines (Figure 5) using solder connectors A002 546 13 41.
Note:
Be careful not to damage the headlamp with the heat gun.
7.11 Tape over the solder connectors with fabric tape.
7.12 Remove the tabs from the 4 holes of the lamp retaining collar A230 826 00 89 (Figure 6, arrows).
7.13 Insert burner and attach to lamp retaining collar. Run the ground contact to the bottom (Figure 7).