C 230 (203.040) L4-1.8L SC (271.948) (2005)
containers.
1
Disconnect ground cable of battery
2
Remove light switch module (S1)
3
Remove cover below instrument panel (left)
4
Remove door sill molding (11)
5
Remove edge guard (12) in area of A-pillar paneling
6
Unclip cap from A-pillar cover (14)
7
Unscrew bolt (13)
8
Unclip A-pillar cover (14), remove
9
Open cable duct on entry panel
10
Disconnect pneumatic connector (3)
CAUTION: Careful, risk of cracks and fracture.
11.1 Disconnect pneumatic connector (5a)
CAUTION: Careful, risk of cracks and fracture.
12
Disconnect pneumatic connector (5b)
CAUTION: Careful, risk of cracks and fracture.
13
Expose pneumatic lines
14
Remove headlamp range controller (1)
15
Install in the reverse order
16
Perform basic programming
NOTE: Only if no quiescent current retention device has been used.
17
Read diagnostic trouble code memory and erase
18
Check for proper function