C 230 (203.052) V6-2.5L (272.920) (2007)
A - Aluminum valve (Tire Pressure Monitoring)
B - Steel valve
C - Rubber valve
Note:
Replacement sub-components, such as nuts, gaskets, seals, spacers, or o-rings must not be used. The valve stem assembly must be replaced in its entirety.
Mounting/Dismounting Process:
When replacing tires with wheel sensors (tire pressure monitoring system) it is essential to observe the following instructions.
Disassembly:
Warning!
The bead breaker shovel of the tire mounting device must not be positioned in the valve area (1). This applies both to the outside and inside of the tire.
(Figure 2)
Disassembly