C 240 4MATIC Wagon (203.281) V6-2.6L (112.916) (2003)
Shown On Model 203
DANGER:
-
Lethal injuries are possible if vehicle slips off of lifting platform
-
Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points
specified by the vehicle manufacturer.
1
Remove right front axle shaft (60)
2
Install new radial sealing ring (32)
NOTE: Coat sealing lip of radial sealing ring with universal hypoid gear oil.
3
Install in the reverse order
4
Check front axle gear oil level and top up if necessary
AR33.30-P-0541P Replace Left Inner Radial Seal at Front Axle Gear
Replace Left Inner Radial Seal At Front Axle Gear
1
Remove front final-drive unit (50)
2
Drain and collect hyped gear oil via the intermediate shaft opening
3
Clamp front final-drive unit (50) to assembly stand
4
Remove bearing cover (54)
5
Remove O-ring (54a) from bearing cap (54)