C 240 4MATIC Wagon (203.281) V6-2.6L (112.916) (2003)
Axle Shaft: Service and Repair
AR33.30-P-0625P Remove/Install Intermediate Shaft & Replace Deep-Groove Bearing
Remove/install Intermediate Shaft And Replacing Deep-groove Ball Bearing
DANGER:
-
Lethal injuries are possible If vehicle slips off of lifting platform
-
Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points
specified by the vehicle manufacturer.
1
Remove left front axle shaft (60)
2
Remove locking ring (36)
NOTE: Installation: Pay attention to correct seating.
3
Pull intermediate shaft out (34) out of the oil pan
NOTE: Model 220: For this purpose raise the suspension strut until the intermediate shaft can be guided through the C-bracket on the suspension
strut.
4
Replace deep-groove ball bearing (35)
5
Check circlip (34a) and replace if necessary
6
Install in the reverse order